Extreme Networks WM-4T1i Spezifikationen PDF herunterladen (Seite 165)

Configuring I/O Modules

Extreme Networks Consolidated Hardware Guide 165

• Install two or less LX100 GBICs per GM-4Xi module and leave the remaining GBIC slots empty

• Install two or less LX100 GBICs per GM-4Xi module and install any combination of the following

GBICs into the empty slots:

— 1000BASE-SX

— 1000BASE-LX

— ZX GBIC

— ZX Rev 03

— LX70

— UTP GBIC

To ensure correct operation of the LX100 GBIC, make sure that you run ExtremeWare 6.1.9 or later on

your switch.

NOTE

For more information about the supported GBIC types, see “GBIC Specifications” on page 32.

LEDs

The GM-4Xi module has the following LEDs:

• Module status

• Port status

For information about the LEDs and their activity on the GM-4Xi module, see “I/O Module LEDs” on

page 176.

GM-4Si Module

Figure 76 shows the GM-4Si module.

Figure 76: GM-4Si module

The GM-4Si module has four Gigabit Ethernet ports using standard MT-RJ connectors. The GM-4Si

module supports 1000BASE-SX only.

The default configuration of the GM-4Si module is as follows. All ports:

• Are added to the default VLAN as untagged.

• Inherit the properties of the default VLAN (protocol type, VLANid, and so forth).

• Operate in autonegotiation mode.

38_GM4

Module status

LED

Port status LEDs

1 234

1000 Mbps ports

1 2 ... 160 161 162 163 164 165 166 167 168 169 170 ... 335 336

Keine Kommentare

Extreme Networks WM-4T1i Spezifikationen Seite 165