Extreme Networks WM-4T1i Spezifikationen PDF herunterladen (Seite 165)

Extreme Networks Consolidated Hardware Guide 9-5

Removing SMMi Modules

Removing SODIMMs from the SMMi Module

To remove a SODIMM:

1 Attach an ESD strap to your wrist and connect the metal end to the ground

receptacle that is located on the top-right corner of the switch front panel.

2 Disengage the SODIMM by pulling out on the ejector locks located on either side of

the SODIMM.

3 Rotate the SODIMM out of the socket.

Removing SMMi Modules

All Alpine 3800 series modules (SMMi and I/O modules) are hot-swappable. You do

not need to power off the system to remove or insert a module.

To remove an SMMi module:

1 Attach the ESD strap that is provided to your wrist and connect the metal end to the

ground receptacle that is located on the top-right corner of the switch front panel.

2 To loosen the module, unscrew the screws using a #2 Phillips screwdriver.

3 Simultaneously rotate the ejector/injector handles outward to disengage the module

from the backplane.

4 Slide the module out of the chassis.

5 If you are not going to install a replacement SMMi, cover the slot with a blank

faceplate. Otherwise, follow the SMMi module installation procedure on page 9-3.

6 Leave the ESD strap permanently connected to the chassis, so that it is always

available when you need to handle ESD-sensitive components.

1 2 ... 160 161 162 163 164 165 166 167 168 169 170 ... 305 306

Keine Kommentare

Extreme Networks WM-4T1i Spezifikationen Seite 165