Extreme Networks Summit WM Series Betriebsanweisung PDF herunterladen (Seite 49)

Altitude AP access approval

Summit WM-Series WLAN Switch and Altitude Access Point Software Version 1.0 User Guide

4 The Altitude AP “learns” the IP address of the Summit WM-Series Switch,

Status LED: orange (blink) when IP address successfully obtained (“Registration” process underway)

Status LED: red (blink) if “Registration” fails

5 The Altitude AP sends its serial number (a unique identifier that is hard coded during manufacture)

to the Summit WM-Series Switch.

Status LED: green (blink) when Altitude AP finds Summit WM-Series Switch (“Standby” status)

6 The Summit WM-Series Switch sends the Altitude AP a port IP address and a binding key, as

follows:

● If the Summit WM-Series Switch does not recognize the serial number, it sends a default

configuration to the Altitude AP.

● If it does recognize the serial number, it sends the specific configuration (port and binding key)

set for that Altitude AP.

The Summit WM-Series Switch also adds the Altitude AP to its database.

Status LED: green (blink) when Altitude AP finds Summit WM-Series Switch (“Standby” status)

7 When the binding key is received, the Altitude AP's status changes from “Standby” to “Active”. It

becomes active and is enabled to transmit data traffic.

LED: green steady (“Active”)

When the Altitude AP has wireless traffic, you will see a green blink on the traffic LED. The left LED

indicates the traffic LED for activity on the 2.4 GHz radio, while the right LED indicates activity on the

5 GHz radio.

Altitude AP access approval

You can also view and modify the status of registered Altitude APs. Use this function to modify the

status of a Altitude AP from “Pending” to “Approved” for a manual registration. You can also delete

the configuration of Altitude APs that are no longer in service.

1 2 ... 44 45 46 47 48 49 50 51 52 53 54 ... 227 228

Keine Kommentare

Extreme Networks Summit WM Series Betriebsanweisung Seite 49