Extreme Networks Summit WM Series Betriebsanweisung PDF herunterladen (Seite 33)

Setting up the data ports

Summit WM-Series WLAN Switch and Altitude Access Point Software Version 1.0 User Guide

2 Click in a port row to highlight it.

3 For the highlighted port, key in the:

NOTE

In a “Branch Office” scenario, where the Altitude AP is configured statically on a local network whose MTU is

lower than 1500, the Summit WM-Series Switch automatically adjusts the MTU size to prevent packet

fragmentation.

4 For the highlighted port, select its Function from the drop-down list: Host Port, 3rd Party AP, Router

(defined below).

For OSPF routing on a port, that port must be configured as a “Router” Port. No more than one port

should be configured as a router port.

5 To allow Management traffic on a highlighted port, click the Mgmt checkbox on. This choice must be

used carefully since it overrides the built-in protection filters on the port.

6 For the highlighted port, click the SLP checkbox on to allow SLP protocol on this port for Altitude

APs using this port for discovery and registration.

7 To save the port configuration, click Save.

To cancel the entries without saving, click Cancel.

IP address IP Address of the physical ethernet port.

Subnet mask For the IP address, the appropriate subnet mask to separate the network

portion from the host portion of the address (typically 255.255.255.0)

MTU Maximum Transmission Unit (maximum packet size for this port). Default

setting is 1500. If you change this setting, and are using OSPF, be sure that

the MTU of each port in the OSPF link matches.

1 2 ... 28 29 30 31 32 33 34 35 36 37 38 ... 227 228

Keine Kommentare

Extreme Networks Summit WM Series Betriebsanweisung Seite 33